Samsung Galaxy Z Flip Top Glass Replacement

Ensure device is completely powered off to prevent damage.

• Set the phone face down on a clean, debris-free surface.
• Avoid placing the phone on any surfaces with abrasive materials or sharp objects that may scratch the screen.

Apply iOpener to left edge of phone for 1 minute.

• Alternatively, use a heat gun, hairdryer, or heating mat to melt adhesive.

• Be careful when using heat gun or hairdryer — risk of damage to battery or screen.

Apply a suction cup to the glass.

If your glass is badly cracked, cover it with clear packaging tape to ensure a good suction cup seal.

• Pull up on the glass while pushing down on the metal part on the hinge until the glass begins to separate from the frame.
• Insert an opening pick into the gap between the glass and the frame.

Slide the pick down to the corner of the phone to slice the adhesive.

Insert no more than a quarter of the pick's length through the phone to avoid damaging internal components.

Place a new opening pick at each corner and reheat that area.

• Apply gentle heat to the chosen area with a hair dryer.
• Wait for adhesive to become soft, then carefully cut it around the phone.

Risk of damage to the ribbon cable: lift the rear glass from the far left side.

• Lift up the rear glass, starting from the far left side of the phone.

Remove the plastic bracket covering the connector using a uspudger.

• Disconnect the ribbon cable from the board using a spudger.
• Follow the installation instructions to reinstall the rear cover and replace the adhesive.

Turn on your device and test the repair before installing new adhesive and resealing it.