Samsung Galaxy S7 Display Adhesive Replacement
This is a companion guide to the Galaxy S7 screen replacement guide, and should be followed to replace the display or screen adhesive only.
Step 1 | Display Adhesive
Remove all adhesive residue and debris from the phone's frame.
- Clean the adhesion surface with high concentration isopropyl alcohol (over 90%).
- Wipe clean with a lint-free cloth.
Left behind adhesive or glass remnants will prevent proper display mounting and may cause damage.
Peel off the clear plastic backing from the pre-cut adhesive strip to expose one side of the adhesive.
Step 2
Line up an edge of the adhesive with the corresponding edge of the phone frame.
- Set the adhesive down lightly on the frame.
- Verify that cutouts match the phone, and camera and sensors are exposed.
- If misaligned, carefully peel the adhesive back up.
Step 3
Run the flat end of a spudger or use your fingers to press the adhesive into place along its perimeter.
- Spudger tip: Press the adhesive firmly into the frame's corners and edges.
- If using fingers, apply gentle pressure to prevent air bubbles from forming.
Step 4
Reassemble your device until ready to attach screen.
- Test screen functionality before attaching, if possible.
Incorrect installation can damage screen and/or phone casing.
- Peel green plastic liner from adhesive strip to expose adhesive.
- Align and set screen on top of exposed adhesive.
- Squeeze around perimeter with fingers to secure adhesive.
Apply at least several books' weight for one hour to ensure strong bond.