Samsung Galaxy S6 Rear Glass Replacement
- Remove the rear glass panel for component access or to replace a damaged panel.
- Rear glass removal warning: This will break the adhesive and require reinstallation.
Step 1 | iOpener Heating
Any debris on the microwave floor can adhere to the iOpener.
Position the iOpener in the center of the microwave.
- In carousel microwaves, ensure the plate rotates smoothly. Sticking can cause overheating and damage.
Step 2
Do not overheat the iOpener (above 100°C/212°F), as it may burst.
- Heat the iOpener in the microwave for 30 seconds, adjusting time based on your microwave's wattage.
- The iOpener is ready when it's barely too hot to touch.
- As needed, reheat the iOpener in 30-second increments throughout the repair procedure.
Do not touch a swollen or overheated iOpener.
- If still too hot to touch, continue using it while waiting for it to cool down.
- A properly heated iOpener should stay warm for up to 10 minutes.
Step 3
Be cautious when removing the iOpener from the microwave as it will be extremely hot.
- Remove the iOpener from the microwave using one of the two flat ends to avoid touching the center.
- Use an oven mitt if handling the iOpener is uncomfortable due to its heat.
Step 4 | Alternate iOpener heating method
Be cautious when handling hot iOner.
- Fill a pot or pan with enough boiling water to submerge an iOpener.
- Turn off heat and let it sit for 2-3 minutes.
- Use tongs to carefully remove the heated iOpener from the pot.
- Dry the iOpener thoroughly with a towel.
- Hold the iOpener by the end tabs only, as it will be very hot.
To reheat, repeat steps 1-4.
Step 5 | Rear Glass
Opening your phone will compromise its waterproof seals.
- Have replacement adhesive ready before proceeding, or take care to avoid liquid exposure upon reassembly.
- Apply packing tape over shattered glass panels to hold them together during removal.
Do not attempt repair without proper precautions against water damage.
- Lay the heated iOpener over the rear panel for two minutes, targeting the edge of the glass.
- Reheat and reapply as necessary to achieve adequate temperature.
Avoid overheating when using heat tools:
- Use caution with a hair dryer, heat gun, or hot plate, as they can cause heat damage to the OLED display and internal battery.
- Shift the iOpener or heat tool to target remaining sections of the panel for an additional two minutes.
Step 6
Heat the rear glass until it's hot to the touch.
- Apply a suction cup near the bottom edge and lift.
- Insert an opening pick into the created gap.
- Optional: Add a few drops of isopropyl alcohol for extra adhesive weakening.
Step 7
Slide the pick along the bottom edge of the phone to slice through the adhesive securing the rear glass.
- Leave the pick in place, then grab a second pick for the next step.
- If necessary, re-heat the rear glass to prevent the glue from cooling and hardening.
Re-heating may be required multiple times to maintain optimal working time for the adhesive removal process.
Step 8
Repeat the heating and cutter procedure for the remaining three sides.
- Insert an opening pick under each edge to prevent reseal of adhesive.
Step 9
- Insert an opening pick to carefully cut away any remaining adhesive.
- Afterwards, remove the rear glass.
Step 10
Remove any remaining adhesive from the phone's chassis with tweezers.
- Clean the adhesion areas with isopropyl alcohol (at least 90%) and a lint-free cloth, swiping in one direction only.
- Peel the adhesive backing off of the new rear glass and align one edge against the phone chassis.
- Firmly press the glass onto the phone, ensuring proper fit and alignment.
Reinstalling old glass or using glass without pre-installed adhesive requires following a separate guide.