Samsung Galaxy S4 Active I537 Charging port Replacement
This guide is specific to the Samsung Galaxy S4 Active AT&T model (SGH-I537) and may not be applicable to other devices.
- Acquire a replacement charging port suitable for the SGH-I537.
- Disconnect the battery connector from the motherboard.
- Remove the necessary screws to access the charging port circuit board.
- Desolder and remove the old charging port.
- Solder and connect the new charging port, ensuring proper alignment of pins.
- Reassemble all components in reverse order.
Step 1 | Rear Cover
Disconnect power source.
- Remove back cover.
- Detach and remove battery.
Step 2 | remove screws
Remove the battery to prevent accidental power-up.
- Use a small Phillips screwdriver to remove the 8 screws on the back.
Step 3 | Covers
Use a prying tool to carefully remove the four access panels.
- Apply gentle to moderate pressure as needed.
- Continue until all four panels are removed, exposing the last four screws.
Step 4 | More screws
Avoid applying excessive force, which may cause damage.
- Remove the 4 screws.
- Pry around the edges with a tool or fingers to remove the plastic back part.
Step 5 | Screws
Remove two screws.
- Take off the white plastic cover.
Step 6 | Antenna cable
Be cautious when disconnecting the antenna cable, as damage can occur.
- Use a prying tool or your finger to carefully unplug the antenna cable.
Step 7
Careful not to damage the connector — use prying tool or your fingers to safely disconnect.
Step 8
Use a prying tool or your fingers to carefully remove the charging port.
- Reverse these steps to install the new charging port