Samsung Galaxy S25 Edge Wireless Charging and Loudspeaker Assembly Replacement

The battery must be drained to at least 25% to prevent a potential fire risk.

• Power down the device completely.
• Unplug all connected cables.

Apply heat to the back cover using an iOpener, or alternative heat sources such as a hair dryer, heat gun, or hot plate.

Mild adhesive secures the back cover; heating it will soften the adhesive, making separation easier.

• Lay the heated iOpener on the bottom edge of the back cover for two minutes to soften the adhesive.
• Alternatively, use a heat source such as a hair dryer, heat gun, or hot plate.

Position the suction handle near the center of the back cover's bottom edge, within 1mm of the edge.

Grasp the suction handle firmly and apply consistent pressure.

Continue to pull up until a visible gap appears between the cover and .

• Insert the tip of an opening pick into the formed gap.

Start by locating the adhesive securing the back cover around the perimeter of the frame.

• Use the reference picture to guide you as you begin to separate the adhesive.

When prying the left and right edge adhesives, be cautious not to insert your tool more than 3mm to avoid damaging the wireless charging coil or interconnect cable.

Apply additional heat if necessary and attempt separation once more.

• Run the opening pick along the device's bottom edge to detach the adhesive holding the back cover in place.

Slide a pick along the entire perimeter of the back cover, separating any remaining adhesive.

• Be cautious not to insert the pick too far under the long left and right edges.

Remove the back cover.

• If necessary, check the perimeter for remaining adhesive and separate it using your opening pick.

Power on your phone and test all functions before sealing it up, but make sure to power down completely afterwards.

Check and clean the rear cameras with a lint-free cloth if necessary.

• Determine where your new back cover adhesive is applied (either to the frame or the back cover).
• Use cutouts and contours to align it properly. If it matches the back cover, follow the original guide; otherwise, follow this alternative guide.

Get the spudger point or the tip of an opening pick under the wireless charging assembly press connector.

• Pry up and disconnect the connector from its top edge.
• If it's hard to get under, try using an opening pick instead.

Keep track of each screw to ensure correct reassembly.

• Remove the wireless charging and loudspeaker assembly using a Phillips screwdriver.
• There are eleven 2.8 mm screws to remove.

Disconnect the wireless charging coil from the loudspeaker using care.

• Pry up and unclip the loudspeaker using angled tweezers by the notch on its left edge.
• Remove the wireless charging coil as part of the assembly for safety.

When reassembling, press down firmly around the perimeter to avoid damage to the loudspeaker clips.

Hold the wireless charging and loudspeaker assembly firmly with both hands.

• Lift upwards carefully using both hands.
• Continue lifting until removed from its mounting points.