Samsung Galaxy S25 Edge Earpiece Speaker Replacement

Allow the battery to discharge below 25% charge to prevent a potential hazard.

• Power off the phone.
• Disconnect all cables and unplug any connections.

Avoid overheating which may damage components.

• Apply heat to the iOpener and place it on the bottom edge of the back cover for two minutes.
• Alternately, use a hair dryer, heat gun, or hot plate to soften the adhesive.

Position the suction handle near the center of the back cover's bottom edge, as close to the edge as possible.

Grasp the suction handle firmly and pull upwards with steady pressure.

• A gap should form between the cover and frame.
• Insert the tip of an opening pick into the formed gap.

Locate the adhesive securing the back cover around the perimeter of the frame and refer to the provided picture for guidance.

• Separate the left edge adhesive, taking care not to insert your pick more than 3 mm to avoid damaging the wireless charging coil and interconnect cable.
• Repeat the process on the right edge.

Apply additional heat if necessary.

• Hold the opening pick against the bottom edge of the device.
• Gently slide the tool to release the adhesive securing the back cover.

Slide your pick carefully along the back cover's perimeter, working to release any remaining adhesive.

• Avoid inserting the pick too deeply at the long edges on the left and right sides.

Remove the back cover.

• If having trouble, check perimeter for remaining adhesive and use an opening pick to separate.
• During reassembly:

• Power on phone, test all functions before sealing up — risk of incorrect assembly.

• Power down phone completely before continuing work.

Inspect rear cameras for smudges and wipe with a clean lint-free cloth if necessary.

• Apply replacement back cover adhesive to either the frame or the back cover.

• Use cutouts and contours to determine best alignment — incorrect placement may damage components.

Insert the pointed end of a spudger or an opening pick between the wireless charging assembly press connector and its top edge.

• Pry gently upwards to disconnect the connector from its socket.
• If needed, use the tip of an opening pick for better leverage.

Label each removed screw for reassembly purposes.

• Use a Phillips screwdriver to remove the eleven 2.8 mm-long screws.
• The screws secure the wireless charging and loudspeaker assembly.

Disconnect the wireless charging coil from the loudspeaker using gentle care.

• Remove the wireless charging coil and loudspeaker as one unit to prevent damage.
• Use angled tweezers to pry up and unclip the loudspeaker at its left edge notch.

Firmly press down around the loudspeaker's perimeter during reassembly to engage its clips.

Hold the wireless charging and loudspeaker assembly firmly with both hands.

• Lift the assembly upwards while maintaining your grip.
• Gently rock it back and forth to dislodge any connectors.
• Once free, carefully pull the assembly away from its mounting points.

Pry at the designated gold arrow marked on the board to avoid damaging surface-mounted components.

• Locate the gold arrow corresponding to the press connector.
• Use a spudger to pry up and disconnect the battery press connector.

Insert the pointed end of the spudger under the earpiece speaker press connector.

Gently pry upwards while ensuring not to damage the surrounding components.

Remove the earpiece speaker using a Phillips screwdriver.

• There are five screws to remove, each measuring 2.8 mm in length.

Insert the flat end of a spudger under the earpiece speaker's lower edge and gently pry it loose.

• For reassembly, press down firmly around the earpiece speaker's perimeter to secure its clips in place.

Remove the earpiece speaker.