Samsung Galaxy S24 Ultra Back Cover Replacement

Do not charge a lithium-ion battery below 25% as it may pose a safety hazard.

• Verify if the battery is swollen and take necessary precautions.
• Disconnect all cables from the phone.

Press and hold the side key and volume down button, then select "Power off" to shut down the device.

Apply a heated iOpener to the right edge of the back cover for 2 minutes.

Be cautious not to overheat the phone, as the display and internal battery are susceptible to heat damage.

• Alternatively, use a hair dryer, heat gun, or hot plate if an iOpener is not available.

Apply a suction handle near the center of the right edge of the back cover.

Use strong, steady force to create a gap between the cover and frame; if needed, apply more heat to soften adhesive further.

Follow iOpener instructions to avoid overheating.

• Insert an opening pick into the created gap.

Insert a pick along the right edge, sliding it back and forth to separate the adhesive.

• Leave the pick in place at the bottom right corner to keep the adhesive separated.

Heat the iOpener and apply it to the bottom edge of the back cover for 2 minutes.

Insert a second opening pick near the bottom of the right edge.

• Rotate the new pick around the bottom right corner to continue separating the adhesive.

Slide the opening pick along the bottom edge of the device.

Leave the pick in place, especially near the bottom left corner, to prevent the adhesive from reforming.

Apply a iOpener preheated according to the manufacturer's instructions to the left edge of the back cover for 2 minutes.

• Insert a third opening pick beside the second one, close to the left side of the bottom edge.
• Rotate this new pick around the bottom left corner to loosen the adhesive.

Avoid damaging the antenna cable — do not insert the pick more than 4 mm.

• Slide your opening pick along the left edge to separate the adhesive, stopping before you reach the power button.
• Leave the pick inserted near the power button to prevent resealing of the adhesive.

Apply a iOpener to the top edge of the back cover and heat it for two minutes.

Insert an opening pick into the gap at the top right edge.

• Rotate the opening pick around the top right corner.
• The goal is to separate the adhesive.

Avoid inserting the pick more than 4 mm, as it may damage nearby components.

• Slide the pick along the top edge to break apart the adhesive.

Insert a pick into the top left corner of the device, sliding it downward along the left edge to loosen any remaining adhesive.

Avoid inserting the pick more than 4 mm to prevent damage to the cameras.

Grab and remove the back cover.

If still attached, use an opening pick to separate adhesive around the edges.

• Power on phone and test all functions during reassembly.
• Ensure phone is completely powered down before proceeding.

Remove any remaining adhesive chunks with tweezers or fingers. If needed, apply heat for separation.

For custom-cut adhesives, follow the dedicated guide.

For double-sided tape, consult its own installation instructions.