Samsung Galaxy S24 Plus Back Cover Replacement

Do not use a charged lithium-ion battery as it poses a potential safety hazard.

• Allow the battery to drain below 25% or check if it is swollen.
• Disconnect all cables from your phone.
• Press and hold the side key and volume down button, then select "Power off" on your phone's screen.

Do not apply excessive heat, which can cause damage to the display and internal battery.

• Apply a heated iOpener to the right edge of the back cover for two minutes.
• Alternately, use a hair dryer, heat gun, or hot plate, but maintain control to prevent overheating.

Apply a suction handle to the back cover near its right edge center.

• Pull up on the suction handle with strong, steady force to create a gap between the cover and frame.

• If necessary, apply more heat according to iOpener instructions to avoid overheating

• Insert an opening pick into the created gap.

Slide a pick back and forth along the right edge to separate the adhesive.

Do not remove the pick, as this will allow the adhesive to reseal.

Apply a iOpener to the bottom edge of the back cover and heat it for two minutes.

Rotate the opening pick around the bottom right corner to break up the adhesive.

Insert a second pick at the bottom right corner.

• Slide the pick to the bottom left corner to separate the adhesive.
• Leave the pick in the bottom left corner.

Do not remove the pick that is holding the adhesive from resealing.

Heat the iOpener and apply it to the left edge of the back cover for 2 minutes.

Position the opening pick near the bottom left corner and gently rotate it to loosen the adhesive.

Insert a third opening pick at the bottom left corner.

• Slide the pick towards the top left corner to separate the adhesive.
• Leave the pick near the top left corner to prevent resealing of the adhesive.

Apply a iOpener to the top edge of the back cover and heat it for 2 minutes.

Hold the opening pick at an angle and rotate it slowly around the top left corner of the device.

• The goal is to pry the adhesive away from the surrounding area, taking care not to scratch any surfaces.
• If necessary, use a gentle twisting motion to loosen the adhesive.

• Insert a fourth opening pick at the top left corner.
• Slide it towards the top right corner to separate the adhesive.
• Leave the pick near the top right corner in place.

Locate the square of adhesive above the flash, near the rear microphone.

• Insert an opening pick into the gap next to the flash, ensuring it's aligned with the surrounding area.
• Squeeze the pick under the top edge of the back cover until you feel resistance from the adhesive.
• Gently pry the cover downward while continuing to apply pressure to the pick, allowing the cover to detach from the adhesive.

Remove the back cover by hand.

If stuck, use an opening pick to gently separate any reformed adhesive.

• Power on your device and test all functions before closing.
• Ensure the phone is completely powered down before continuing.
• Use tweezers or fingers to remove all adhesive from the back cover and phone.
• If necessary, use heat, isopropyl alcohol (90% or greater), and a coffee filter or lint-free cloth.
• For custom-cut adhesives, refer to this guide.