Samsung Galaxy S20 FE 5G Rear Camera Lens Cover Replacement

Apply iOpener or use a hair dryer (be cautious of heat damage) to the bottom edge of the back cover for 2 minutes.

• Use an iOpener and apply it to the bottom edge of the back cover.
• If using a hair dryer, exercise caution as extreme heat can warp the back cover.

Apply a suction cup to the center of the back cover's bottom edge.

• Pull up on the suction handle with strong, steady force to create a gap between the cover and frame.
• This may require significant force; if necessary, apply more heat and try again.

Insert an opening pick in the created gap.

Insert an opening pick into the bottom right corner.

• Slide the pick along the bottom edge to cut the adhesive securing the back cover.
• Leave the pick inserted to prevent the adhesive from resealing.

Apply a iOpener to the right edge of the back cover and heat for 2 minutes.

Alternatively, use a hair dryer, but be cautious not to apply extreme heat, which may warp the back cover.

Insert an opening pick into the bottom right corner of the device.

• Slide it along the right edge, carefully slicing through any adhesive.
• Once completed, leave the opening pick in place at the top right corner.

Excessive heat may warp the back cover; use with caution.

• Apply a heated iOpener to the top edge of the back cover for two minutes.
• Alternatively, use a hair dryer, but keep extreme heat at bay.

Slide the opening pick to the top right corner, then along the top edge, to slice the adhesive.

• Leaving the pick inserted in the top left corner.

Excessive heat can damage or warp the back cover.

• Apply a heated iOpener to the left edge of the back cover for two minutes.
• Alternatively, use a hair dryer, but with caution: avoid extreme heat that may harm the back cover.

• Insert the opening pick into the top left corner.
• Sweep the pick along the entire left edge to remove remaining adhesive.

Remove the back cover.

• If the back cover remains stuck to the frame, use an opening pick to gently pry around the perimeter, separating any remaining adhesive.

Power on your device and test all functions before reassembling.

Make sure to power down completely before continuing work.

• If reinstalling old back cover: Remove old adhesive with tweezers or fingers, then use isopropyl alcohol and microfiber cloth for remaining residue.
• Follow guide for applying new custom-cut adhesive (for reusing old back cover).

For new back cover: Peel off liners, press firmly around perimeter to secure.

Excessive heat can damage the back cover.

• Use an iOpener or hair dryer to apply heat to the rear camera lens cover for two minutes.
• Be cautious not to warp the back cover with extreme heat.

Remove the rear camera lens cover by prying it loose with a spudger.

• Insert the flat end of a spudger into the top camera cutout from beneath the back cover.
• Push the lens cover until it starts to detach.
• Slide an opening pick between the lens cover and back cover.

Slide opening pick under rear camera lens cover, moving it back and forth to cut adhesive.

Remove the rear camera lens cover.

• Install a new lens cover by peeling off the old adhesive with tweezers; this will leave no residue.
• Align the lens cover using the camera's cutouts for proper orientation.
• Remove the plastic liner from the back of the new lens cover.
• Lay the lens cover in its recess and press down firmly to secure it.