Samsung Galaxy Note10 Plus 5G Wireless Charging Coil Replacement

Completely power off your phone.

• Prepare an iOpener and apply it to the left edge of the rear cover for one minute.
• iOpener, hair dryer, heat gun or hot plate may be used, but avoid overheating which can damage the display or internal battery.

Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible.

• If the rear cover is badly cracked, apply clear packing tape over it before using the suction cup.
• Alternatively, use very strong tape instead of a suction cup or superglue one to the broken cover if needed.

Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame.

• If the rear cover is not easily removable, apply more heat to the edge and try again.
• Once a gap has been created, insert the point of an opening pick into it.

Slide opening pick along left edge towards bottom left corner.

• Do not insert more than halfway into phone —

  risk of damaging internal components

  .
• Leave the pick in place to prevent adhesive re-sealing.

Continue heating and cutting for the remaining three sides.

• Leave an opening pick on each side before moving on.
• Prevent the adhesive from resealing by maintaining a pick on each side.

The rear cover will begin to separate as you finish all sides — be prepared for this.

Remove the rear cover by lifting it straight up.

• To reinstall the rear cover, refer to the original installation guide.
• For replacement adhesive instructions, see the separate adhesive reapplication guide.

Ensure your device is powered on and functioning properly before applying new adhesive and sealing.

• For Tesa tape application guidance, consult the linked resource.

Remove the wireless charging coil's 5 4 mm screws using a Phillips screwdriver.

Use tweezers to lift and flip back the metal shield covering the battery connector.

Hold the metal shield aside with one hand.

• Use the pointed end of a spudger to gently pry up the battery connector.

Disconnect the wireless charging coil connector using the pointed end of a spudger.

Locate and tilt the metal shielding upwards.

• Grip the metal shielding firmly with your fingers.
• Peel the wireless charging coil away from the device.

The wireless charging coil is secured with light adhesive — be gentle to avoid damage.

• Remove the wireless charging coil.