Samsung Galaxy Note Edge Volume Button Replacement
Failing to adjust the volume can indicate a faulty volume switch. Replace it using this guide.
Step 1 | Volume Button
Place device flat on a clean surface.
- Remove the back cover with a Spudger, inserting into the notch at the top left.
Step 2
- Remove the battery by inserting a Spudger into the notch beneath it.
No battery was available during guide development; refer to manufacturer's documentation for proper removal procedures if needed.
Step 3
Remove the stylus from its protective case.
Step 4
Remove fifteen 4mm screws with a Philips #000 Screwdriver.
Step 5
Remove the black chassis using a Spudger.
- Expose the motherboard
Step 6
Disconnect the connection 1, connection 2, and connection 3 using a spudger.
Step 7
Disconnect the front camera wire.
- Locate the front camera wire and gently pry it loose from its connector.
- Once disconnected, set aside the wire and proceed with the repair.
Step 8
- Leave the motherboard in place until the final step.
- Use a Spudger to gently lift it.
- Disconnect the daughter board connection.
- Remove the motherboard.
Step 9
- Remove the volume button panel.
- Disconnect and remove the volume button connection.
- Delete the entire volume button assembly.