Samsung Galaxy Note Edge Vibrator Replacement

Power down your device completely.

• Verify that your device is fully shut off.
• Place the device face-down on a clean, flat surface.

Use a spudger to pry open the back cover at the top left corner.

• Apply the spudger to the notch beneath the battery and gently lift it out.
• (Note: Our device was without a battery during guide creation)

• Slide out the SIM card from its holder, moving it horizontally.
• Retrieve the stylus from its designated holder.

Remove the rear chassis using a Phillips #000 Screwdriver: fifteen 4mm screws.

• Careful prying — risk of damage to surrounding components.

  Insert your spudger into the stylus socket and separate the midframe from the phone.
• Move the spudger around the edge of the phone, gently prying the midframe until entirely separated.

Disconnect the pink and white wires with the pointed end of your spudger.

• Locate the finger print scanner cable, situated directly above the pink and white cables.
• Using the pointed end of your dpudger, disconnect the finger print scanner cable.

Avoid damaging the delicate components — use the pointed end of your Spudger.

• Pry off the lead connecting the Front Facing Camera to the logic board.
• Disconnect the AMOLED Display Screen from the logic board.
• Pull out the lead for the AMOLED Capacitive Screen.

Insert the spudger's pointed end underneath the motherboard at the top.

• Lift the motherboard up gently using the spudger.
• Disconnect the cable connecting the daughter board, which is attached to the underside of the motherboard.
• Remove the motherboard from the device.

Insert the sharp end of the spudger under the golden cables.

• Gently pry upwards to disconnect them.

Strong force may be needed to separate the vibration motor from its adhesive mount.

• Insert one end of the Tweezers into the notch on the device.
• Pry upwards and grasp the round part of the motor to dislodge it.