Samsung Galaxy Note 4 Headphone Jack Replacement

Insert fingernail or plastic opening tool into the divot to the left of the rear-facing camera.

• Pry gently while twisting to remove the flexible rear cover.
• Continue prying and twisting until the rear cover comes off completely from the back of the phone.

Insert a fingernail or plastic opening tool into the recess at the bottom right corner of the battery.

Lift upward to release the battery.

• Remove the battery.

Push the SIM card slightly out of its housing.

• Pull the card the rest of the way to remove it completely.

• Remove the 16 4.0mm Phillips #00 screws holding the midframe to the display assembly.
• Remove the S Pen from its slot in the midframe by grasping the cap and pulling it out.

Insert a plastic opening tool between midframe and display assembly.

• Work plastic opening tool around phone's perimeter to break adhesive.
• No heat gun required, as adhesive is relatively weak.

Careful not to separate front glass panel from rest of display assembly.

Insert the plastic opening tool into the gap and gently pry the clasps away from the battery housing.

Apply sufficient pressure to separate the display assembly from the midframe.

• Push on the battery housing to release the two parts.
• If your new midframe lacks a headphone jack assembly, carefully transfer it from the old one using plastic opening tools and remove the retaining plastic pins.

• Remove the headphone jack using a plastic spudger and tweezers.

Use a pry tool to gently lift the headphone jack from its position on the midframe.