Samsung Galaxy Note 3 Display Assembly Replacement

Insert a plastic opening tool into the gap between the rear case and the base of the phone.

Slide the plastic opening tool along the edge of the rear case.

• Lift the case gently from its base.

• Insert a fingernail or plastic opening tool into the gap between the battery and phone base.
• Lift the battery out of its recess.

Insert the stylus pen into the phone's charging port.

• Pull the stylus pen straight out of the port.

Remove the 12 x 4mm Phillips #00 screws from the back chassis.

• Insert a plastic opening tool into the Stylus Pen placement holder.

• Lift the tool to separate the midframe from the base.

Remove the screw located beside the headphone jack.

• Remove the antenna clips using tweezers.
• Disconnect six cable connectors with a spudger.

Hold the motherboard firmly in place with one hand, then use the other to carefully grasp it with a pair of tweezers.

Insert the plastic spudger into the headphone jack.

Lift the spudger to pry apart the jack assembly and motherboard.

Pull downwards to completely remove the jack assembly.

Locate and remove the metal bracket situated in the top left corner.

Careful not to damage the surrounding components.

• Hold the vibrating motor firmly in place with one hand.
• Use the tweezers to gently pull the motor upwards.

Lift the USB port from the front assembly using the tweezers.

Remove and retain all non-display components.

The remaining unit is the display assembly.