Samsung Galaxy Mega Rear Facing Camera Replacement

Ensure the device is completely turned off.

• Locate the slot on the top left corner of the phone's back panel.
• Insert a plastic opening tool or your fingernail into the slot and pull up to release the back plate.
• Slide your finger around the device between the back plate and the phone to release connectors.

• Push your fingertip into the battery release slot.

• Gently pull upwards on the battery to avoid damage or injury.

• Remove the battery from its housing.

Potential cosmetic damage: use a metal spudger at your own risk.

• Remove the 14 x 3.45 mm Phillips #000 screws.
• Insert a plastic opening tool into the seam above the volume buttons.

Slide a plastic opening tool slowly around the device to release internal connectors.

• The device should separate easily once the tool has been fully applied.
• During reassembly, ensure proper alignment of volume and power buttons.

Remove the 2.55 mm Phillips #000 screw from the motherboard panel.

Disconnect the connector clips from the motherboard.

Disconnect and remove all motherboard connectors.

Disconnect all connectors shown in the pictures.

• Lift the motherboard gently with your finger.
• Remove six connectors from the motherboard.

Locate and disconnect the rear-facing camera connector on the motherboard.

Damage to the motherboard may result if the camera connector is not properly disconnected.

The camera module is now separated from the device.