Samsung Galaxy Mega 2 Screen & Digitizer Assembly Replacement
- Replace the screen on your Galaxy Mega 2 with this guide.
Using a hair dryer or heat gun can damage components; consider alternative methods.
- Pry off the old screen using appropriate tools.
- Apply adhesive to secure the new screen in place.
Step 1 | Screen & Digitizer Assembly
Ensure the phone is turned off.
- Locate the charging port slot at the bottom of the phone's back panel.
- Insert a plastic opening tool or use your fingernail to release the back cover by pulling up on it.
- Once the corner is released, slide your finger along the edges until the back cover detaches.
Step 2
- Find the battery.
- Gently use a plastic opening tool or fingernail to lift it out.
- Once freed, take out the battery.
Step 3
Remove all PH000 Phillips head screws with a size of 1.4 mm.
- Pry the Digitizer cover off using a careful approach and a pry tool.
- Use the pry tool to disconnect the digitizer.
Step 4
Insert the pry tool along the side of the device.
- Work your way around the borders of the screen to separate it from the rear assembly frame.
Do not lift the screen completely off yet — leave it at an angle.
Use a heat gun to heat up the bottom, loosening the adhesive around the menu and back buttons.
- Once heated, gently pull the screen upward.
- Verify that the buttons are separating from the adhesive.
Step 5
Separate the screen from the bezel.