Samsung Galaxy Mega 2 LCD/Digitizer Replacement
To replace the LCM (LCD + Digitizer) assembly, you'll need to remove the screen by taking out a few screws first.
Step 1 | LCD/Digitizer
Turn off the phone before proceeding.
- Locate the charging port at the bottom of the phone and find the slot beside it.
- Insert a plastic opening tool or use your fingernail to gently pry up the back cover, starting from one corner.
- Slide your finger around the edge until the back cover releases.
Step 2
- Identify the battery.
- Caution: Insert a fingernail or plastic opening tool into the slot on the bottom and gently lift up.
- Remove the battery.
Step 3
Remove the Digitizer cover using a pry tool.
- Use a Phillips head screwdriver PH000 and remove all 13 screws, 1.4 mm in length.
- Pop the Digitizer cover off using a pry tool.
- Disconnect the Digitizer connector using a pry tool.
Step 4
Insert a pry tool along the side of the device.
- Work your way around the borders of the screen, separating it from the rear assembly frame.
- Leave the screen at an angle and do not lift it completely off yet.
Use a heat gun to heat up the bottom and loosen the adhesive from the menu and back buttons.
- Gently pull the screen upward once heated.
- Ensure the buttons are separating from the adhesive.
Step 5
- Flip the screen over.
- Identify the LCD/Digitizer.
- Disconnect the LCD/Digitizer using a pair of tweezers.