Samsung Galaxy J3 Eclipse Display Assembly Replacement

Use a heat gun or hair dryer to heat up the front edges of the phone for about 2 minutes.

Keep approximately 6 inches away from the screen to prevent damage.

• Avoid applying heat to one edge for more than a few seconds.
• Instead, use a continuous motion around the phone's edges with the heat gun or hair dryer.

Use caution when separating the screen and frame to avoid damaging internal components.

• Insert a pry tool between glass display and phone's frame while adhesive is still warm and flexible.
• Slowly slide another pry tool around all edges, breaking adhesive's bond to the display.
• Do not apply excessive force as this may damage internal components.
• Avoid inserting pry tool more than 1cm into top edge to prevent damaging fragile cables.

Loosen the lower side of the device by gently prying it away from the frame.

• Lift and release each edge, allowing the screen to hinge upwards at the bottom.
• Do not attempt to fully remove the display at this stage.

Use your prying tool to gently pry up the bottom right corner of the cable guard, exposing a thin ribbon cable connector.

Be careful when handling sharp edges.

• Pry up the ribbon cable connector hidden under the cable guard.
• Remove the display from the device.
• Clean any residue from the phone's edges before reassembling with the new screen.