Samsung Galaxy A54 5G Rear Cameras Replacement

Completely power off your phone.

• Remove the SIM card holder.

Loosen the adhesive with an iOpener applied for at least two minutes on each side, or use a hair dryer, heat gun, or hot plate while taking care not to overheat (display and battery risk damage).

Attach a suction handle to the edge of the back cover, near the edge.

• If the back cover is cracked, secure the suction handle with strong tape or superglue and let it cure.

It may take multiple attempts to lift the cover successfully. Be cautious not to overheat the adhesive while using heat.

• Lift the back cover with the suction handle, creating a small gap between the cover and frame.
• Insert an opening pick into the gap.
• Slide the opening pick along the phone's side to break the adhesive, leaving it in place to prevent re-sealing.

Insert a second opening pick at the bottom edge of your phone.

• Slide the opening pick along the side of the phone to slice the adhesive.
• Leave the opening picks in place to prevent the adhesive from resealing.

Reapply heat as needed, using the iOpener for 1-2 minutes.

• Slide the opening pick along each side of the back cover to slice the remaining adhesive.
• Leave a pick on each side to prevent resealing.

Remove the back glass.

• Remove the motherboard cover using a Phillips #000 screwdriver.
• The screws are nine in total and measure 4.4 mm long.

Locate the tweezers.

• Position the tip of the tweezers under the right edge of the motherboard cover.
• Pry up the motherboard cover using the tweezers.

Disconnect the battery cable using a pair of tweezers. Prying the connector straight up from its socket.

Remove the interconnect cable using a pair of tweezers.

• Pry the connector straight up from its socket.

Remove the screw securing the motherboard using a Phillips #000 screwdriver.

• The screw is approximately 3 mm long.

Disconnect the red and white antennas using a pair of tweezers.

• Insert tweezers under the motherboard assembly
• Pry up with tweezers to release the motherboard assembly from the phone body.
• Remove the motherboard assembly.

Use tweezers to lift and detach the macro camera press connector.

• Lift the macro camera away from the motherboard.
• Remove the macro camera completely.

Remove the main camera by lifting it off the motherboard.

• Pry up and disconnect the main camera press connector using a pair of tweezers.
• Remove the main camera from the device.

Remove the ultra wide camera by lifting it off the motherboard.

• Use a pair of tweezers to pry up the press connector.
• Once disconnected, carefully lift and remove the ultra wide camera.