Samsung Galaxy A20e Display Assembly Replacement

Remove the Display Touch Screen Assembly with Frame.

• Begin by disconnecting any cables connected to the display.
• Carefully lift the assembly out of its frame, taking note of any retaining clips or screws.

• Remove the SIM tray.
• To proceed, use a plastic opening tool to remove the back cover.
• When removed, press the Touch ID to unstick it from the back cover.

Use a Phillips Screwdriver to remove all the screws.

• Employ a Plastic Opening Tool to safely detach:
• The Antenna Assembly
• The Touch ID Fingerprint Sensor, disconnecting and then removing it completely.

Remove the Logic Board Plastic Cover.

• Remove the Sup-board Plastic Cover.

Disconnect the battery first to avoid any accidental power-ons.

• Insert the spare part into its designated slot.
• Verify the spare part's proper installation and function.

Careful handling is required to avoid damaging these fragile cables.

• Disconnect the Battery.
• Separate the Sup-board Flex Cable.
• Release the Coaxial Antenna Cables

Be cautious when handling electronic components to avoid damage.

• Detach the Sup-board Flex Cable.
• Remove the Volume buttons Flex Cable.
• Carefully lift out the Logic board, taking note of the camera locations to avoid damage.

Do not apply excessive heat — risk of damaging the surrounding components.

• Apply hot air to soften the adhesive.
• Remove the sub-board using a plastic spudger.

Use caution when handling flammable liquids.

Apply a few drops of alcohol to the battery terminals.

Allow the device to warm up for a short period of time.

Transfer Rceiver, Vibromotor, and Loudspeaker.

• Remove transport tapes from Silicon Thermal Pad
• Remove transport tapes from Front Camera Hole

Use Hot Air to facilitate the removal process.

Install the battery to the new frame using double-sided adhesive tape.

Successful outcomes often mask earlier difficulties.