Samsung Galaxy A11 Display Assembly Replacement

• Insert the SIM eject tool into the sim tray hole.
• Pull until the SIM tray partially protrudes.
• Continue pulling to fully remove the SIM tray.

Insert an iFixit opening pick into the area near the SIM tray on the back cover.

• Gently move the pick along the gap and pry open the clips holding it together.
• If possible, use multiple picks to secure the back cover in place.

• Use a hair dryer on low heat to heat the fingerprint sensor in 30-second increments.
• Pry gently at the fingerprint sensor until it detaches from the back cover.
• If necessary, remove the button by prying it loose from the bottom of the device.

• Use a Phillips #000 screwdriver to remove the three 3 mm screws securing the shield.
• After removing the screws, carefully lift and detach the shield from the phone.

• Disconnect the battery press connector using tweezers, a spudger, or your fingers.

Avoid puncturing the expanded battery — handle with extreme care.

• Apply low heat from a hairdryer (if not an expanded battery) to loosen adhesive under the battery.
• Insert the iFixit pry tool along the edge of the battery.
• If necessary, use multiple iFixit pry tools to secure the battery in place.
• Continue cutting adhesive until the battery can be safely prised free.

• Do not puncture or damage the expanded battery!

• Remove the battery from the phone.

Use tweezers to carefully lift the copper strip located at the top right of the phone.

Use a Phillips #000 screwdriver to remove the three black 3 mm screws holding the speaker cover in place.

• Remove the speaker cover.
• The cover should now be free from the phone.

Remove the earpiece speaker using tweezers.

• If necessary, apply heat from a hair dryer to loosen the adhesive.
• Use gentle motion when handling metal tools to avoid device damage.
• Orient the tweezers as needed for secure grip, horizontally or vertically.

Use a spudger to detach the ribbon cable connected to the fingerprint sensor.

• Remove the fingerprint sensor from the device.

Use a Phillips #000 screwdriver to remove the two 3 mm silver screws located at the top left of the device.

Disconnect the two ribbon cables at the battery slot using a spudger.

• Remove the two longer ribbon cables near the bottom right corner of the motherboard.
• Lift these cables up slightly to reveal a gap between them and the motherboard.

Use a spudger to gently pry up the motherboard.

• If necessary, use a metal spudger for added stability.
• Beware: metal spudgers require gentle handling to avoid damaging internal components.
• Once pried up, carefully remove the motherboard from the device.

Remove the eight silver and black 3 mm screws with a Phillips #000 screwdriver.

• Remove the speaker cover.

• Disconnect the antenna heads from the daughterboard using a spudger.
• Remove the ribbon cable from the daughterboard.

Be careful with metal tools to avoid damaging the device.

• Use tweezers to gently pry the daughterboard from the device.
• Gentle handling of the device is crucial when using metal tools.

Remove the vibrator motor using a pair of tweezers.

• If necessary, apply gentle heat with a heat source to release the adhesive bond between the motor and its mount.

The display assembly is a self-contained unit that can be removed and replaced independently.