Samsung Epic 4G Camera Lens Replacement

Slide your fingernail along the edge of the device and gently pull the plastic backing.

You will know it's detached when you hear a snapping sound.

Remove the plastic backing by gently pulling on it, listening for the snap sound that indicates it is free.

Release the battery by gently lifting its edge upwards.

Locate the memory card in the upper right-hand corner of the device.

• Slide the memory card out of its holder using your fingers, taking care not to touch any other components.

Remove screws with a Phillips #000 screwdriver.

• Use a nylon spudger to pry apart the backing and silver trim around the phone.
• Most buttons, including the power button, will fall out during this process.

Use tweezers to remove the power button, if it remains.

• Replace the old power button with a new one from a reputable manufacturer.

Do not rip the white cables out of the device.

• Remove the white cable along the right side of the device using a nylon spudger.
• Pull both ends of the white cable out until they snap into place without excessive tension.

Remove the screw with a Tri-Point Y0 screwdriver.

• Snap the antenna assembly out gently.

Use a nylon spudger to gently pry the top flex cable loose.

• Remove the larger flex cable from the left side, located below the smaller one.

Lift out the motherboard.

• Locate the USB port on the top edge.
• Replace it with a new part from the same manufacturer.

Replace the existing camera lens with a new one from a reputable manufacturer.

• Obtain a replacement camera lens from the original equipment manufacturer or an authorized supplier.
• Follow the manufacturer's instructions for removal and installation of the new lens.