OnePlus Nord N200 Speaker Replacement

Inserting the Jimmy into the seam between the rear glass and midframe requires some force.

A thin slicing tool is necessary due to the suction tool's inability to grip the phone's rear glass.

• Insert the Jimmy at the bottom edge of the phone, creating a gap between the rear glass and midframe.
• Leave the Jimmy in place for a few seconds to prevent the adhesive from resealing.

• Insert an iFixit opening pick into the gap.
• Slide the Jimmmy around the phone to slice adhesive.
• Insert a second iFixit opening pick where you've sliced open the adhesive.

Insert an iFixit opening pick at the top edge of the phone.

• Pry the pick along the top edge, slicing through the adhesive.
• Continue prying the back plate off the phone.

Remove back cover.

Be cautious of the hidden screw indicated by the orange circle.

• Use a Phillips #00 screwdriver to remove the sixteen screws, each 3.6 mm long, securing the midframe.

Insert the Jimmy gently to create a gap between the midframe and top components.

• Slide an opening pick around the edge of the midframe to slice the adhesive.
• Use the Jimmy to pry off the midframe.

Remove the midframe by hand, carefully prying it open completely.

Be cautious when handling the back tray as the fingerprint reader cable remains attached – risk of damage if not handled with care.

• Lift the midframe off the phone and set it aside.

Position a spudger under the fingerprint cable connector's edge.

Pry straight up carefully to avoid damaging the connector.

• Move the fingerprint reader cable aside along with the midframe.

Remove the midframe.

Risk of electrical shock: disconnect battery from charger before proceeding.

• Place a spudger or opening pick under the connector's edge and pry straight up to release the battery.
• Pry carefully under the connector's edge, not the socket on the board. Damaging the socket may be irreversible.
• Avoid prying near surface-mounted components or scraping them accidentally.

Permanently damage the connector or pins: never force a connector into place.

• Reconnect by aligning the connector over its socket and pressing down carefully, first one side then the other.
• For wider connectors, press down only after they are fully seated to avoid bending or breaking the pins.

Insert an iFixit opening pick under the speaker assembly.

• Lift up the iFixit opening pick to carefully pull out the speaker assembly from its tray.
• The speaker assembly should come out easily, but if not, check for any missed screws.

Disconnect the speaker wires from the circuit board.

• Lift out the speaker assembly from its compartment.
• Set aside for later reinstallation.