OnePlus Nord 2 5G Rear Glass Replacement

Prepare an iOpener by applying it to the rear glass for at least three minutes.

Be cautious when using a hair dryer, heat gun, or hot plate as excessive heat can damage the phone's display and internal battery.

No suction tool will hold onto the phone's rear glass due to its surface.

• Use a thin slicing tool to create a gap between the rear glass and the midframe.
• Apply force as needed when inserting an iFlex into the seam at the bottom edge of the phone.
• Leave the iFlex in place to prevent adhesive resealing.

Insert an iFlex opening pick into the created gap.

• Remove the iFlex.

Insert the opening pick into the bottom right corner and carefully slice the adhesive.

Never remove the opening pick until the repair is complete, as this can cause the adhesive to reseal.

• Insert a second opening pick at the bottom right corner.
• Slide it to the bottom left corner to cut the adhesive.

Leave both opening picks in place to prevent resealing.

Reheat the adhesive using your iOpener if it becomes hard to cut.

• Insert a third opening pick at the bottom left corner of your phone.
• Slice along the left edge of your phone using the opening pick.
• Leave one opening pick in the top left corner to prevent resealing.

Insert a opening pick into the top left corner of the rear glass.

• Slide the pick along the top edge to cut through the adhesive.
• Leave the pick in place at the top right corner to prevent resealing.

Insert a fifth opening pick under the top right corner.

• Slide it along the right edge of the back cover.
• Slice the remaining adhesive with the opening pick.

• Remove the back cover.
• Secure the new back cover with pre-cut adhesive or double-sided adhesive tape.

Apply strong, steady pressure to your phone for several minutes after installing the back cover to ensure a good bond.

• A stack of heavy books can be used to apply even pressure.