OnePlus 6 Lower Frame Replacement
Charging issues, poor audio quality from headphone jack, or distorted audio from speaker may require repair; ensure components are free of debris before proceeding.
- Review troubleshooting page to determine if issues can be resolved without part replacement.
- Powers down OnePlus 6 and disconnects all power sources.
- Carefully removes the phone's glass back panel; be aware of potential shattering risk.
Step 1 | Back Panel
Never apply excessive heat, which can melt the plastic.
- Turn on the heat gun and set it to a low temperature.
- Carefully heat the curved edges of the phone's back cover.
- Insert opening picks between front and back panel, then slide them around the perimeter to break the adhesive.
- Repeat until the back panel is fully released.
Step 2
Be careful not to damage the fingerprint sensor ribbon cable when lifting the back panel.
Step 3
- Grasp the red tab with a pair of tweezers and gently pull upwards to release the cable.
- Remove the back panel completely from the device.
Step 4 | Lower Frame
Use a Phillips #00 screwdriver to remove the eight 3 mm screws from the lower frame.
- Lift the lower panel gently upwards and out of the device.