LG Vortex Rear Facing Camera Replacement
Replacing the rear-facing camera on an LG Vortex requires patience and care due to its compact and delicate internal components.
- Power off the device and disconnect it from the charger before proceeding.
- Gather a few small tools and work in a clean, static-free environment.
The camera module needs to be replaced if your LG Vortex is taking blurry photos or experiencing issues with focusing or launching the rear-facing camera app.
Step 1 | Power down the Phone
Power down your phone completely.
The power button is situated at the top edge of your device.
Step 2 | Remove the Back Cover
Locate the thumbnail ridges on the side (next to the micro SD slot) and top of the phone.
- Use a blue plastic opening tool to pry the back cover away from the rest of the phone.
- Remove the back cover and set it aside.
Step 3
Use the blue plastic opening tool to remove the battery.
Be aware of the small thumbnail ridge at the top left corner, which helps with removal.
- Remove and set aside the battery.
Step 4 | Unscrew the Back Frame
- Collect all required tools.
Using a #00 screwdriver head is critical for this repair.
A precision screwdriver is the recommended tool for this task.
Remove all 6 screws using the same screwdriver.
- 2 top edge screws (1 in each corner)
- 2 middle edge screws (on the sides)
- 2 bottom edge screws (in each corner)
Place the removed screws in a container to prevent loss.
Step 5 | Remove the Back Frame
Use a blue plastic opening tool to remove the back frame.
- Pry at the micro SD slot, and gently push the cover for the SD slot away from the front of the phone.
- Pry your way around the entire phone to separate the face from the frame.
Step 6 | Rear Facing Camera
This step is particularly challenging.
- Locate the system board inside and identify the camera module area at the top.
- Find the black plastic component surrounding the camera, which sits on but isn't soldered to the board.
- Pry the two black tabs securing it outward (away from the board), being careful not to let them snap back onto the board.
Step 7
Avoid damaging the speaker cable near the camera.
- Remove the black plastic piece next to the camera with a blue prying tool.
Step 8
Insert a spudger or opening tool under the camera connector edge and pry straight up.
- Pry under the connector edge, not the board socket, to avoid damaging it.
- Lift the black camera housing away from the system board using a prying tool.
- Work along its edges gradually, avoiding cable tugs.
Step 9
Caution: Be careful not to damage thin wires when prying away the sticker.
- Pry the small sticker or adhesive tab on top of the camera module away from the board using your fingernail.
- Lift the camera straight up and off the board, then pull it off the system board using your fingers.