LG V30 Plus Motherboard Replacement

Heat two iOpeners in a microwave and apply them to the phone's edges.

Allow 1-2 minutes for the adhesive to heat up.

• If necessary, use a heat gun to assist with separating the backing.

Insert a Opening Tool between the rear glass and side of the phone.

• Pry the glass off just enough for an Opening Pick to be inserted.
• Use the Opening Tool to pry around the edges, placing additional Opening Picks as needed.

Use a Suction Handle to carefully remove the rear glass.

• The rear glass should come away from the device once all edges are lifted.

Use your Phillips #00 Screwdriver to remove the ten 4mm screws.

Gently push down on the small black tab with a Spudger to release the protective board.

• Slide an Opening Tool between the phone and the protective board, and slide along the edges of the phone to unclip it.
• Wiggle the board back and forth while gently pulling to unclip the last attachment point.

Insert an Opening Tool between the lower protective board and the phone.

• Slide the tool along the edges, working towards one corner.
• The protective board should pop off as the tool reaches its edge.

Gently pry each ribbon cable away from the motherboard to disconnect.

Remove the motherboard from the phone with care.