LG G2 Sprint Vibe Motor Replacement
Most disassembly is required to access the vibe motor, so carefully keep track of each screw and part removed.
- Paying special attention, note any parts glued in place, as these may be missed during reassembly.
Step 1 | Charger Port
Flip your phone over and use a plastic opening tool to pry open the phone case.
- Slide the tool between the two sides of the phone case, working towards the bottom.
- Gently pry the case open with consistent pressure until you hear the clip pop open.
Release the top left corner clip carefully as it can be stubborn.
Step 2
Remove the outer phone case.
- Prepare two Phillips head bits: one J0 and one J000.
- Use J0 bit for all 11 silver screws.
- Use J000 bit for the small black screw.
Step 3
Locate the upper left clip on the upper panel and use a plastic opening tool to gently pry it loose.
- The upper inside panel should now flip up easily, removing all clips and screws first is crucial.
- If the panel doesn't come off smoothly, double-check that you have removed all necessary screws.
- Also, carefully pry away any ribbon cables from the board to prevent damage.
Step 4
Ensure all screws are removed before attempting to pry the bottom panel.
- Pry the bottom inside panel back carefully.
- If it does not come off easily, recheck for any remaining screws.
Step 5
Take care not to damage any connected ribbon or wires.
- Identify and release the clips and circuits marked in the images above, using a flathead screwdriver.
- Use your tools to carefully disconnect cables at the connectors, avoiding damage along the wire.
Step 6
Release the clips and circuits indicated by circles in the provided images.
- Bend the orange material along the dotted line, keeping the fold as close to it as possible.
- Be cautious when handling ribbon or wires to avoid damage.
Step 7
Disconnect all ribbon and antennae connections.
- Pry the board up gently from the bottom of the case.
- Slide the board back out, ensuring all ribbon connectors are removed first.
Step 8 | Vibe Motor
Remove the vibe motor by gently prying it away from the phone case using a plastic prying tool.
When handling sensitive components like the camera, always use a plastic or ESD safe tool to avoid damage.