LG Fortune Rear Camera Replacement

Locate the slit on the bottom right side of the phone.

• Insert a plastic spudger into the slit and slowly pry the back cover off, working your way up from the bottom.

Pry the battery up from the case using the slot at the middle of the bottom edge.

Use a PH000 screwdriver to remove the ten 4mm screws on the back panel.

• Remove the back panel using your fingers or a spudger.
• Work slowly side to side to release the back casing and expose the motherboard.

Caution: Using a metal spudger can damage your device.

• Remove the video card from the motherboard using a plastic opening tool or a spudger.

Careful not to damage the device — using a metal spudger may cause harm.

• Unplug the front facing camera press fit connector from the motherboard by prying upwards with a plastic opening tool or spudger.

Potential for damage: use an ESD-safe tool instead of metal spudger.

• Unplug the rear facing camera ribbon cable from the motherboard using a plastic spudger.
• Pry up the press fit connector carefully to release it from the motherboard.

Locate the top-left corner and gently pry downwards towards the bottom-right corner using a spudger.

• Pry carefully, working your way around the edge.
• Be cautious not to damage any surrounding components.

Use a metal spudger to carefully pry up the camera, applying sufficient force as needed.

• Get underneath the tape holding the camera in place.
• Pry the camera out of its position using gentle yet firm pressure.