LG Ally VS740 Camera Replacement

Hold the phone firmly with one hand.

• Flip the battery pack open using your other hand.
• Remove the battery cover.

• Remove the battery.

Slide the phone open.

• Locate the thick casing on the edges around the keyboard.
• Remove this casing, starting with the following steps:

• Place two fingers on the back plate where the battery was located.
• Use your thumb and place it on the edge of the thin casing near the top.
• Pry around the casing from left to right using your thumbnail or a prying utensil.

Be careful not to damage any internal components during this process.

Use your prying tool to carefully lift the green circuit board platform off the black casing.

• Gently disconnect the tether's connection point from the green circuit board.

When handling internal components, avoid touching any electrical contacts to prevent damage or injury.

Flip the phone over and locate the camera section on the other side, where three small clips secure a black casing.

• Gently pry off these clips using your hands or the prying tool.

Locate the flash module, a white rectangle with a yellow square, covering the tether section where the camera is.

• Gently lift up and disconnect the flash module.
• The camera connection point should now be visible. Pry the camera module off the board with calm pressure.
• Realign your new camera module and reattach it to the original point of disconnection.
• Once in place, realign the flash module's connection point back to its original hole. Push down firmly until snug.

Reassemble in reverse order, ensuring all components are securely attached.