Lenovo Vibe Z2 Pro Ear Piece Speaker Replacement

Remove Torx head screws with a 4.9 mm bit.

• The screws are located on the camera plate at the back of the device.

Remove the 3.65 mm Torx head screws located at the bottom of the phone.

Insert a pin into the small hole located on the side of the phone.

Be careful not to push too hard and damage the surrounding area.

Insert Spudger into gap between phone and backplate, pushing it gently.

Pull the backplate gently away from the phone.

Remove the protective film from the surface using your fingers.

Use a black nylon spudger to carefully remove the adhesive strips holding the battery in place.

• Gently pry the strips away from the battery using your fingernail or the spudger.
• Prioritize using a black nylon spudger due to its effectiveness around sensitive components like batteries.

Use a spudger to carefully lift and disconnect the orange battery ribbon cable.

Locate the battery.

• Insert a fingertip or spudger into both sides of the battery.
• Lift the battery upward and remove it from your phone.

Remove Phillips Head #000 screws with 3.15mm socket size.

• Use tweezers to carefully lift the black cable hinged clips.
• Pull the ribbons away from their connectors.

Disconnect the rear-camera connector gently.

• Remove the front-facing camera by gently lifting its connector tab.
• Use a spudger to carefully lift the remaining connector.

Remove top edge plastic brace using a pry tool.

Remove the antenna attached to the bottom piece of the screen plate.

Remove the motherboard from the frame by gently lifting it.

• Next, carefully pull the camera module out from behind the motherboard.

• Disconnect the charging port assembly cable using a spudger.
• Next, disconnect the screen connection cable.
• After that, remove the motherboard completely.

Insert tweezers under the speaker, then gently lift it out.