How to Replace the Screen Adhesive for Your Google Pixel 7 Pro

Residual adhesive or debris can prevent proper screen sealing.

• Scrape off excess adhesive using the flat end of your spudger.
• Peel and remove remaining adhesive with tweezers or fingers.

Avoid puncturing the battery to prevent potential fire or chemical leak risks.

• Clean the frame perimeter with highly-concentrated isopropyl alcohol (>90%) and a lint-free cloth.

Inspect and clean the screen as done with the .

Align the new adhesive with the phone's frame by laying it on top.

• Refer to the front-facing camera for left-right orientation.
• Locate the upper loudspeaker and corner notches for added guidance.

Remove the clear protective backing by pulling on the adhesive tab at the top.

Be extremely cautious — misaligned adhesive can lead to an improper seal.

• Lay the adhesive onto the frame from the bottom edge up.
• Make small corrections as you go, using the bottom left notch, top right notch, and upper loudspeaker cutout for alignment assistance.

Firmly press adhesive along frame's perimeter using a spudger or fingers.

Grasp the pull tab located at the lower right corner of the frame.

• Pry off the main liner.
• A secondary, smaller liner will be exposed; refrain from removing it for now.

Inspect the front-facing camera hole and sensor cutout on the replacement screen.

Remove all remaining protective liners from these areas.

Continue with your phone's guide for reassembly instructions.

• Reinstall the display cable bracket.
• Complete reassembly once the screen is installed and sealed in place.

Grab the pull tab on the upper left of the frame.

• Remove the liner covering the perimeter adhesive, ensuring it does not stick to the adhesive.

• Screen must be flipped over.
• Lay the screen face down on the frame.
• Press the edges of the screen firmly to secure it in place.

Account for the camera bar when compressing the Pixel screen.

• Use screen vise clamps and secure to the device perimeter if available.
• Apply tape to protect rear glass finish.
• Place thick objects (coins, etc.) along rear glass edges, at least as thick as the camera bar.
• Stack heavy objects on phone for 30 minutes or overnight.