How to Replace the Adhesive for Your Google Pixel 6
This guide, written by iFixit staff, is not affiliated with Google. For more information on our guides, visit our website. Apply new adhesive to your repaired Google Pixel 6 screen using the steps below.
- Ensure you've removed your Pixel's screen beforehand; if not, follow the screen removal guide.
Step 1 | Clean the frame
Any residual adhesive or debris will prevent screen sealing.
- Scrape off excess adhesive using the flat end of your spudger.
- Avoid damaging spring connectors near the frame perimeter.
- Use tweezers or fingers to remove remaining adhesive.
- Clean the frame with isopropyl alcohol (over 90%) and a lint-free cloth.
Step 2 | Clean the screen
Clean the reused screen with the same method used for the
Step 3 | Orient the adhesive
Place the new adhesive over the frame to determine its correct position.
- Align the adhesive using reference points like the upper loudspeaker cutout, lower left hole, and upper right hole.
Step 4 | Remove the adhesive backing
Remove the protective backing by pulling the tab at the top of the adhesive.
Exposing the adhesive may cause it to bond with surrounding surfaces — ensure proper handling and placement.
Step 5 | Apply the adhesive
Careful handling is crucial during this step as misaligned adhesive can lead to an improper seal.
- Apply the adhesive to the frame, beginning with the bottom or top edge, making small corrections as needed.
- Use the holes in the bottom left and top right corners for alignment assistance.
Step 6
Careful not to damage the spring connectors near the perimeter.
- Firmly press along the adhesive's perimeter with a spudger or your fingers.
- Ensure the adhesive adheres properly to the frame.
Step 7 | Remove the liners
Grasp the pull tab located at the top left of the frame.
- Pull downwards to remove the Main Liner.
Step 8 | Check for liners
Verify that the front-facing camera hole and sensor cutout on the replacement screen match your original screen.
- Remove any remaining protective liners from the camera hole and sensor cutout.
Step 9 | Continue reassembly
Reconnect the screen connector bracket during reassembly.
- Continue following the steps in your phone's user guide.
- Seal the device once your screen is securely in place.
Step 10 | Remove the final liner
Puncturing the battery with tweezers can result in chemical leaks or fires.
- Grasp the pull tab on the lower right frame and remove the liner covering the adhesive.
- Ensure the adhesive remains attached to the frame, not the liner.
Step 11 | Install the screen
Flip the screen over.
- Lay the screen onto the frame.
- Press along the perimeter of the screen to secure it.
Step 12 | Strengthen the adhesive bond
Camera bar interference must be addressed to compress Pixel screen.
- Use screen vise clamps to work around camera bar, securing to device perimeter.
- Apply tape to rear glass for finish protection and place coins or thick objects along edges (camera bar thickness).
- Stack multiple heavy objects on phone (e.g. books), leaving in place for at least thirty minutes or overnight.