Google Pixel 2 Display Adhesive Replacement

Remove all old adhesive from the Pixel 2 case.

• Also remove any remaining adhesive from the back of your display if reusing it.
• Carefully collect and discard small glass fragments during this process.

Failure to remove all glue residue may compromise the seal.

Thoroughly clean adhesion areas with high concentration isopropyl alcohol (at least 90%) for a secure display installation.

• If your new display lacks speaker grilles or a front-facing camera bracket, install them before applying adhesive.

Remove the protective covering from the new adhesive.

Careful not to damage the adhesive.

• Locate the perforations on the inner and outer edges of the adhesive strip.
• Tear along the perforations to separate the outer portion from the backing.

Only remove blue plastic surrounding the edge, do not touch the white or blue backing underneath.

Peel away the white backing to expose one side of the adhesive strip.

• Place the exposed side of the adhesive strip down on the phone case, ensuring the blue backing is up.
• Begin at the bottom edge of the case and align the contours of the adhesive strip with those of the case.
• Lay down the remaining portion of the adhesive strip.

Align the adhesive with the edges of the case.

• Press the adhesive strip down against the case using a finger or spudger.

• Be careful not to tear or remove the adhesive.

• Remove the inner portion of the blue backing with tweezers, holding the adhesive down if necessary with a spudger.

Hold the tweezers over the blue backing and gently peel it away from the adhesive.

• If the backing starts to come loose with the backing, use a spudger to keep the adhesive attached to the case.