ASUS FonePad 7 Vetro/Touch Replacement

Ensure the device is turned off.

• Use a plastic opening tool to gently pry the back panel away from the device's edges.

Remove adhesive strips.

• Disconnect the battery connector: Carefully pull down on it with a spudger or plastic opening tool.

Remove all Touch Connectors using a spudger or plastic opener tool.

• Next, disconnect the ZIF connectors holding the battery.
• Alternatively, use your hand to remove ZIF connectors.

Be careful when removing ZIF connectors as they are delicate.

Be careful when prying the battery, as it may be stuck to its mounting pad.

• Use a plastic opening tool to gently pry the battery loose from its pad.
• A bit of pressure may be required to completely remove the battery.

Disconnect the cable.

• Remove the two Philips #0 screws holding the power management board in place.
• Remove the remaining Philips #0 screw.

Remove the GPS antenna using a spudger.

• Disconnect the GPS connector.

Disconnect the power and volume connector.

Disconnect the Earpiece connector.

Disconnect the Display connector from the motherboard.

Remove four Philips #0 screws from the motherboard.

Disconnect all cables and wires from the circuit board.

• Remove any screws or clips holding the components in place.
• Gently lift out each component by its edges, taking care not to touch pins or terminals.

Insert the skill here.

Insert expertise here.